【概述】当温湿度控制器运转后,湿度实际值一直无法到达设定值,且湿度实际值低于湿度设定值很多
After temperature humidity controller starting, humidity actual value till can’t reach the setting value and lower than the setting value.
检查步骤: Check steps
1、查看是否湿度部份的固态继电器烧毁断路: 如果加热器未烧毁,使用用电表交流电压档,电压档位开到600伏特的位置,将红黑棒分别放在线号标注为H的那一颗固态继电器交流两侧,将温度部份的湿度设定值设置100%,此时湿度部份的固态继电器的指示灯会亮起,如果量测的电压值没有变化,维持在220V或者380V,则代表固态继电器烧毁呈现断路状态。
Check if the humidity of solid state relay burned and turn off circuit: If heater is not burning, use in AC voltage meter gears, gear drive voltage to 600 volts, will be red and black on the annotation of line number for H that a solid state relay communication on both sides, set the temperature of humidity value to 100%, humidity at this time of solid state relay will flashing lights, if the measured voltage value did not change, maintained at 220V or 380V, represents solid state relay burned show breaker state.
2、查看保险丝是否烧毁; Check if the fuse burns.
3、查看是否加湿桶加热器烧毁:将加湿桶加热器两条线剪断,使用三用电表欧姆档,量取电阻值,如果电阻呈现无限大,代表加热器烧毁。
Check if humidifying barrel and heater burn: cut off the two of the humidifying barrel and heater, use the three-meter ohmmeter and measure the resistance, if the resistance appears to be infinite, it means the heater will be burnt out.
解决办法: Solutions
1、更换湿度部份的固态继电器(线号标注为H的那一颗固态继电),或者通知售后上门进行维修;
Replace the solid state relay of the humidity part (the one marked with the line number of H), or notify the after-sales staff to conduct on-site maintenance.
2、更换同规格保险丝; Replace fuses of the same specification.
3、通知加湿桶加热器的商家, 或者通知售后上门进行维修。
Notify the business of the humidification barrel and heater, or notify the after-sales service for on-site maintenance.
梅特勒-托利多,METTLER-TOLEDO(纽约证券交易所代码:MTD):世界上首台替代法单盘天平的fa明
梅特勒-托利多,METTLER-TOLEDO(纽约证券交易所代码:MTD):世界上首台替代法单盘天平的fa明
任何测量都存在误差,由于测量的客观真值无法得知及测量条件的非理想化,使误差大小无法确定为了使测量误差减到Z小
该附件是在原DMA上增加了一个密封的样品室,额外增加一个湿度发生及控制器,从而使温度达到5°C120°C,湿
检测灵敏度高,温湿度控制稳定性好,配备单独的加热炉,可根据测试需要,更换相应的选配件,操作简便,可满足样品在
用实际体系调试QCM的说明,根据所提供的实验方法及结果调试及检验PAR公司电化学适应晶体分析仪的工作状态 Q
湿度挥发性和灰含量是衡量诸如燃料食品塑料等产品性能的重要指标热重分析仪可以非常快速的测量上述指标分析过程中,
主要介绍美国HunterLab LabScan XE在番茄酱行业的实际应用,仪器的结构完全符合美国USDA所
本文就我司(北京金先锋光电科技有限公司)对道路照明评价指标的阈值增量TI的实际测试方法做出新的研究旨在更严苛