「制冷器/HPLC Column Chiller/Heater」价格、参数、图片

为你推荐

产品详情：

PRODUCTS ECHOthermTM Model CO30 HPLC Column Chiller/Heater Model CO30 Features: Front-opening door for easy, unobstructed mounting of columns, valves, tubing, and fittings. Mounting hole provided in the door for Rheodyne valves models 7175, 7725, 8125, or 9125 Capacity for four 30 cm by 1" columns. Large capacity with a small footprint Energy efficient Peltier based. (No refrigerator. No CFC's). Temperature range from 4.0 °C to 70.0 °C. Convection chil领 and heating for even chamber temperature. Settable and controllable to 0.1 °C digitally. PID temperature control. RS232 port for programming ramp and soak cycles, remote control, and data collection Separate valve and spill drains to outside the chamber. Electronic calibration with automatic power failure reset. Electronic timer with alarm in hrs/mins/secs to 99:59:59 with user settable Auto-Off. Chamber size: 15.625" (39.69 cm) tall by 6.385" (16.28 cm) wide by 5.125" (13.02 cm) deep. Twelve month warranty. CE approved. Product Description: The Torrey Pines Scientific Model CO30 Chil领/Heating HPLC Column Oven is completely solid state. The only moving parts in the unit are the chamber fan and the coo领 fan. This makes the design of the CO30 truly reliable. Being Peltier based, it has no compressors or CFC's to worry about. This design makes the unit very energy efficient using only 230 watts of power maximum. That is less than many light bulbs. The display is 5/8" (15.88mm) high liquid crystal and reads to 0.1 °C. Temperature accuracy is 0.2 °C over the entire range from 4.0 °C to 70.0 °C. The unit features single point electronic calibration for accuracy that is easily reset by the user to agree with local laboratory standards. The display can be changed from temperature to timer with a single key stroke. The timer reads in hours, minutes, and seconds from 99:59:59. The timer counts down and will alarm at zero. It also can be set to Auto-Off the heater/chiller when the timer counts down to zero. The keyboard is a tactile touch membrane with audio feedback. It has UP Arrow, DOWN Arrow, Heater, Timer, and Auto-Off keys. To set a temperature or timer just touch the appropriate key and the UP or DOWN arrow until the display scrolls to the setting desired. The unit will then execute the command. The display will toggle between the target and actual temperatures when in the temperature mode. Also, all commands are backed up by a circuit that senses power failures and makes certain that the unit goes back to the set temperature when the power fails and then returns. A flashing temperature light lets the user know when a power failure has occurred. The Model CO30 has several safety features. On power-up, it does a self check of all functions. If anything is wrong, the unit will not power up, and will display the letter "E" along with a number which refers to the problem as listed in the instruction manual. The Model CO30 also has a watchdog circuit to monitor the microprocessor for errors. The chamber of the Model CO30 was designed for easy, unobstructed access to the columns, valves, and fittings. The chamber is epoxy painted aluminum and resistant to most solvents. The chamber is large, 15.625" tall by 6.385" wide by 5.125" deep. The mounting posts for the columns are mounted on the door so that when the door is open, the columns, valve and fittings are out in the open for easy access. There are four mounting posts, each measuring 5.0" in length by 0.5" in diameter. The columns are held to the posts by Viton "0" rings supplied with the unit making mounting and changing columns easy, and removing the mass of metal clamps from the chamber. . There are drains in the chamber for the valve and for any leaks onto the floor of the chamber. The tubing required is 1/8" ID. The valve drain comes through the base of the door. The chamber drain comes through the bottom of the unit near the front. The unit has a painted aluminum chassis complete with three-wire grounded, detachable AC line cord and instruction manual. The high and neutral lines are both switched and fused for safety. The CO30 can be ordered in 100, 115, and 230 VAC, 50/60 Hz models. Product Specification: Temperature: Range 4.0 °C to 70.0 °C Readability 0.1 °C Accuracy 0.2 °C Stability ±0.2 °C Sensor Type Solid State IC Controller Type PID Uniformity ±0.5 °C Convection Fan Yes Timer: Range 00:01 hrs/mins to 99:99 hrs/mins Readability 1 second Audible Alarm Yes Auto-Off Yes Electrical: Heater/Chiller Peltier, 100 watts Power Consumption 230 Watts AC AC Switched and Fused Yes, high and neutral AC Line Cord --Detachable, 3-wire, 6.5 foot (3 meter) Electrical 100 VAC, 50/60 Hz, 2 amp 115 VAC, 50/60 Hz, 2 amp 230 VAC, 50/60 Hz, 1 amp Chamber Dimensions: Height 15.625 inches, (39.69 cm) Width 6.385 inches, (16.28 cm) Depth 5.125 inches, (13.02 cm) Overall Chassis: Height 25.5" (64.77 cm) Width 8.75" (22.23 cm) Depth 13.25" (33.66 cm) Valve hole diameter 1.625" (4.13 cm) Accessories Available: O-ring for column clamping, small, 4-pack O-ring for column clamping, large, 4-pack PRODUCT ECHOthermTM Model CO30 HPLC Column Chiller/Heater

您可能感兴趣的产品

制冷器/HPLC Column Chiller/Heater

报价：面议
已咨询1962次

冷冻干燥机/冻干机
Cole-Parmer HPLC Column Chiller/ Heater (Multi) 90–260 VAC, 50/60 Hz

报价：面议
已咨询302次

色谱分析产品
Cole-Parmer HPLC Column Chiller/ Heater Programmable Oven, 90–260 VAC, 50/60 Hz

报价：面议
已咨询304次

色谱分析产品
无锡冠亚电池深冷器Chiller

报价：面议
已咨询559次

制冷加热控温系统
HEATER, COLUMN BATH

报价：面议
已咨询124次

其他附件
恒温混匀器（制冷）

报价：面议
已咨询46次

粉碎/混合/分散
EPPENDORF CH-500 HPLC COLUMN HEATER SYST EM 240V WITH UK CORD

报价：面议
已咨询216次

实验室耗材
Cole-Parmer HPLC Column Heater, Compact 90–260 VAC, 50/60 Hz

报价：面议
已咨询427次

色谱分析产品

上海电威贸易有限公司为你提供制冷器/HPLC Column Chiller/Heater信息大全，包括制冷器/HPLC Column Chiller/Heater价格、型号、参数、图片等信息；如想了解更多产品相关详情，烦请致电详谈或在线留言！: 移动端：制冷器/HPLC Column Chiller/Heater

相关品类
同厂商产品
同类产品
相关厂商

您可能还在找

新品推荐: 分析天平

满足您基本需求的天平： 120 g 处理能力，0.1 mg 可读性，背光液晶显示屏，内部调整，金属机架,实验室天平持久耐用。坚固的结构和高质量材料确保您多年获得准确的结果,zuixin的称量技术和超大的高对比度显示屏确保轻松地读取稳定、准确的结果。; 气动隔膜泵

QBY-40型气动隔膜泵是目前国内zuixin颖的一种采用压缩空气为动力源，通过气阀往复运动分配空气，带动隔膜挤压输送介质的容积式泵，该泵集杂质泵、自吸泵、泥浆泵、屏蔽泵、潜水泵等输送机械的优点。该系列泵具有结构美观，良好的物理抗性，经久耐用等特点，对于各种腐蚀性液体、带颗粒、高粘度、易挥发、易燃、易爆、剧毒的液体、陶瓷釉浆、果浆、胶水、油轮仓底油回收、临时倒罐等液体均能予以抽光吸尽，尤其可以解决叶片式泵的跑、冒、滴、漏及不允许空转等问题，该系列产品可利用普通干净的工业气或仪表气，在0.1公斤的低压下启动，在正常输送状况下节约用气量30%以上，是新一代的节能性泵种，具有良好的市场前景。; 针阀

Stainless Steel Integral Bonnet Needle Valve, 0.73 Cv, 12 mm Swagelok Tube Fitting, Regulating Stem; THERMO 记号笔

细尖纤维笔尖可在冷湿的表面书写。快干型墨水可在塑料上做永久标记；正常使用时，在玻璃、金属或瓷器上书写可以用水或酒精洗掉。; Sheen 不锈钢比重杯

0; SWAGELOK 针阀

美国SWAGELOK世伟洛克SS-1RS12MM-A针阀B-1RS12MM-A; Hamilton 注射器/样校针

Hamilton进样针Z优异的品质：世界上*支精密的进样器来自于Hamilton富有开创性的设计及生产制造，从Z优质的材料到Z严密的生产控制，对细节的极ng准把控已成为Hamilton产品的标志; FMI 微量泵头

zuida流速 (mL/min)：48；zuida流速 (冲数/min)：600；zui高压力 (psi)：100；吸程（湿式） (in H₂O)：180；吸程（湿式） (mm H₂O)：4572；触液材料：316 SS, carbon；准确性：±0.1%；zui高温度 (° F)：140；zui高温度 (° C)：60；zuida粘度 (cP)：500；工作周期：持续Yes；直径 (in)：0；描述：Series Q Valveless Piston Pump Head, SS/SS/Carbon; 0.08 mL/rev