线距线宽怎么翻译英文

pigletsun 2010-03-25 06:04:42 667 浏览

参与评论

登录后参与评论

全部评论(2条)

qq2715404164 2010-03-26 00:00:00

线距网络释义线距:distance between stitchings|line-spacing 迹线滑距:trace slip 瞄准线瞄距:line of sight 线宽 [xiàn kuān] 基本翻译 {光} {电} line width 网络释义线宽:line width|line weight|LW LWEIGHT 谱线半宽:line half-width 谱线致宽:line broadening

赞(11)

回复(0)

评论

评论
登录后参与评论
贜鍡焢 2010-03-26 00:00:00

line space / line width 研究了微流控芯片中大线距/线宽比条件下的UV-LIGA制作工艺。 The fabrication of microfluidic chips by UV-LIGA process with the large ratio of line space to line width was studied.

赞(1)

回复(0)

评论

评论
登录后参与评论

热门问答

线距线宽怎么翻译英文:

数据采集的英文怎么翻译？:

如何用CAM350和PROTEL分别测量PCB的线宽、线距和孔径大小？:

翻译以下英文：: The standard error of the mean (SEM) is a measure of how far your sample mean is likely to be from the true population mean. The SEM is calculated by this equation:SEM=SD/N. With large samples， the SEM is always small. By itself， the SEM i... The standard error of the mean (SEM) is a measure of how far your sample mean is likely to be from the true population mean. The SEM is calculated by this equation:SEM=SD/N. With large samples， the SEM is always small. By itself， the SEM is difficult to interpret. It is easier to interpret the 95% confidence interval， which is calculated from the SEM. 展开

金相切割机控制系统的英文怎么翻译: 金相切割机控制系统的英文怎么翻译？

机床上光栅尺用英文怎么翻译？: 机床上光栅尺用英文怎么翻译？

机床上光栅尺用英文怎么翻译？:

梅毒旋转振荡器的英文怎么翻译:

五分类血球分析仪的英文怎么翻译: 好象都是专业词汇吧... 好象都是专业词汇吧展开

求翻译英文文献: 2.2. Material Characterizations. A field emission scanning electron microscope (SEM， JEOL 6701F) was used to investigate the morphologies， particle sizes of the samples. Transmission electron microscopy and elemental compositions of the ... 2.2. Material Characterizations. A field emission scanning electron microscope (SEM， JEOL 6701F) was used to investigate the morphologies， particle sizes of the samples. Transmission electron microscopy and elemental compositions of the samples were determined by JEM-2100F (JEOL) coupled with an energy-dispersive X-ray spectroscopy (EDX， Phoenix) system. Wide-angle and low-angle X-ray powder diffraction (XRD) of the as-obtained samples were recorded on a Rigaku D/max-2500 with Cu Kα radiation (λ = 1.540 56 Å) operated at 40 kV and 200 mA. Raman measurements were performed using a DXR from Thermo Scientific with a laser wavelength of 532 nm. To calculate the pore size distribution and pore volumes， the nitrogen absorption and desorption isotherms were measured at 77.3 K with an Autosorb-1 specific surface area analyzer from Quantachrome. The content of N in N-doped porous carbon was determined by NHC elemental analysis using Flash EA 1112. Thermogravimetric (TG) analysis of S/C composite was performed on TG/DTA 6300 in an N2 flow to obtain the S content in the composite. A four-contact method was applied to measure the powder electronic conductivity of porous carbons. The powder sample was pressed to disk at 4 MPa with two stainless-steel plungers， whose resistance was measured by a Keithley 2400 digital multimeter in fourwire mode. The conductivity of the sample was calculated according to the resistance and the size of the disk. Information of the surface elements was obtained by X-ray photoelectron spectroscopy (XPS) performed on the Thermo Scientific ESCALab 250Xi using 200 W monochromatic Al Kα radiation. The 500 μm X-ray spot was used for XPS analysis. The base pressure in the analysis chamber was about 3 × 10−10 mbar. All reported data of XPS binding energy are calibrated based on the hydrocarbon C 1s line at 284.8 eV from adventitious carbon. Spectra were fitted with Lorentzian−Gaussian functions and smart background using Thermo Avantage software. 展开

求助，英文文献翻译！: 2. Experimental 2.1 Materials Nano-CaCO3 particles (D50: 30−70 nm by TEM (Fig. 1) and BET: ca.17m2·g-1) were supplied by Shanghai Zhuoyue Nanotech Corporation. Methyl methacrylate (MMA， Shanghai Lingfeng Chemicals) was purified ... 2. Experimental 2.1 Materials Nano-CaCO3 particles (D50: 30−70 nm by TEM (Fig. 1) and BET: ca.17m2·g-1) were supplied by Shanghai Zhuoyue Nanotech Corporation. Methyl methacrylate (MMA， Shanghai Lingfeng Chemicals) was purified by distillation under reduced pressure; potassium persulphate (K2S2O8， initiator， Shanghai Lingfeng Chemicals) was of chemical grade. Silane coupling agent A174 (γ-methacryloxypropyltrimethoxysilane) was purchased from Shanghai Yaohua Factory. Polyvinylchloride (PVC， WS-1000S) was supplied by Shanghai Chlor-Alkali Chemical Co.， Ltd. Fig. 1 Morphology of untreated CaCO3 nanoparticles. Fig. 2 Morphology of PMMA-coated CaCO3 nanoparticles. 2.2 PMMA emulsion polymerization on CaCO3 nanoparticles 2.2.1 Surface silanation of nano-CaCO3 particles The nano-CaCO3 particles were homogeneously dispersed in ethanol (solid content 20%) by a sonication dispersion equipment. The slurry was then heated to 80°C with stirring， and the silane coupling agent A174 (5%， calculated based on the weight of nano-CaCO3 particles) was added into the slurry. After the slurry was stirred for 120 min at 80°C， it was filtered and the filter cake was then dried at 120°C in low vacuum for 120 min to obtain silanated CaCO3 powders. 展开

求助，英文文献翻译~: PMMA has good compatibility with PVC due to specific interaction of a hydrogen bonding type between carbonyl groups (C=O) of PMMA and hydrogen from (CHCl) groups of PVC (Belhaneche-Bensemra et al.， 2002; Ramesh et al.， 2002). Zhou et al... PMMA has good compatibility with PVC due to specific interaction of a hydrogen bonding type between carbonyl groups (C=O) of PMMA and hydrogen from (CHCl) groups of PVC (Belhaneche-Bensemra et al.， 2002; Ramesh et al.， 2002). Zhou et al. (2001) studied the relationship between the coating thickness of PMMA on the surface of talc and mechanical properties of PMMA-g-talc/PVC composites， and found that there existed a critical thickness. Xie (2001) found that the PMMA coating on talc improved the dispersion of talc in the PVC matrix and enhanced the interfacial adhesion between talc and PVC. There appears to be a critical coating thickness of PMMA on the talc surface for optimum toughening. Quan et al. (2002) reported improved toughness and intension of the PVC composites filled with CaCO3/ACR core-shell complex particles prepared by in-situ emulsion polymerization of acrylic ester. In the present work， PMMA coated on the surface of CaCO3 nanoparticles by in-situ emulsion polymerization was characterized by FT-IR and 1H-NMR. The effects of PMMA thickness and particle fraction on the mechanical properties of PMMA-coated CaCO3 /PVC nanocomposites were also investigated. 展开

翻译英文~专业类的: Whilegraphene，acarbon-basedtwo-dimensionalnanomaterials，hasreceivedanupsurgeofinterest，[1]self-assemblyofsmallorganicandorganometallicmoleculesinto2Dnanostructurescouldal... While graphene， a carbon-based two-dimensional nanomaterials， has received an upsurge of interest，[1] self-assembly of small organic and organometallic molecules into 2D nanostructures could also be harnessed to develop new classes of functional supramolecular nanomaterials.[2] In principle， quasi-2D lamellae or nanosheets are planar structures having a thickness less than 100 nm and lateral dimensions a few orders of magnitude greater than their thickness. Control over the bilateral intermolecular noncovalent interactions is anticipated to organize small molecules into regular 2D nanostructures， which has been a formidable challenge yet to be achieved. Recently， Shelnutt and co-workers obtained discrete porphyrin nanosheets reprecipitated from their solutions;[3] Sathish and co-workers constructed hexagonal C60 nanosheets using a liquid–liquid interfacial precipitation method;[4] the groups of Yao[5] and Hu[6] prepared singlecrystalline nanosheets of polycyclic aromatics using a surfactant- assisted reprecipitation and a physical vapor transporting method， respectively; and Zhang and co-workers suggested that molecules with intramolecular charge-transfer dipole moments could be grown into quasi-2D nanostructures.[7] Moreover， some amphiphiles and organogelators were found to self-organize into sheet-like nanostructures in contact with solvents.[8] Despite these advances， templateand surfactant-free synthesis of free-standing， crystalline， and optoelectronically active nanosheets from small molecules remains elusive. 展开

纳米材料英文文献加翻译:

求翻译，除湿机功能按钮英文！: Z主要是模式那三个真的搞不明白。

？？？？？谁能帮我翻译几个英文——激光雷达？？？？？: 关于激光雷达的论文 1、LO 2、header board 3、inductive beams

“双辊开炼机”英文如何翻译？:

通信方面的英文文献翻译！！: 以下是文献的一部分，愿意帮忙的高手留下邮箱，我把文件发给你，若能完成，加分：SpatialCompressiveSensingApproachForFieldDirectionalityEstimation.I.INTRODUCTIONVarietyoft... 以下是文献的一部分，愿意帮忙的高手留下邮箱，我把文件发给你，若能完成，加分： Spatial Compressive Sensing Approach For Field Directionality Estimation. I. INTRODUCTION Variety of techniques for field directionality estimation were studied in literature [1]-[5]. Thus， a theoretical analysis of the relationship between the hydrophone array output and the noise field was conducted in [1]-[5]. The developed techniques were based on the array beamformer output or the crossspectral matrix between outputs of array elements [4]-[5]. The problem of a field directionality estimation in ocean， using horizontal line towed array was also addressed in literature [5]- [8]. Recently， problems of direction of arrival and field directionality estimation for moving sensors arrays have attracted renewed interest [9]-[12]. It was shown that an array motion can improve an array performance assuming temporal coherence of successive samples [10]-[11]. In [12]， the wavefield sampling method that exploits the linear relationship between the noise field and the collection of beamformer outputs over various array orientations was proposed. It was shown that the wavefield sampling (WS) method outperforms other tested methods. This algorithm was implemented via the recursive estimation method and its convergence to the unique solution was promised for a specific set of array orientations and beamformer look directions. However， a method for a proper array orientation and beamformer look direction sequence selection remains an open question. The quality of the field directionality estimation is determined by the angular resolution. The higher angular resolution is， the more accurate estimation of the far field sources， and better detection performance can be achieved. One of fundamental relations in the array signal processing is that the angular resolution is directly proportional to the number of the array elements [13]. This relation motivates the desire for longer arrays that can achieve higher resolution. Unfortunately， the requirement contradicts the implementation and installation limitations that motivate shorter arrays. Moreover， implementation of longer arrays for maneuvering platforms such as unmanned underwater vehicles (UUV) can even be impossible [14]. These contradictions motivate the quest for alternative array signal processing methods. Usually， the field directionality is modeled as a finite set of strong far-field narrow-band sources and an isotropic lowpower noise [1]. In this work， the model of the field directionality is adopted in the following way. First， the bearing angle space is uniformly sampled into a large number of discrete angles. Next， it is assumed that ether the high energy that corresponds to the far-field strong sources or the low-energy that corresponds to the isotropic noise is received at the sensor array from every of these discrete azimuth angles. 展开